-- Raspberry Pi LPC1114 I/O Processor interrupt test program -- Copyright (C)2013-2026, Philip Munts, President, Munts AM Corp. -- -- Redistribution and use in source and binary forms, with or without -- modification, are permitted provided that the following conditions are met: -- -- * Redistributions of source code must retain the above copyright notice, -- this list of conditions and the following disclaimer. -- -- THIS SOFTWARE IS PROVIDED BY THE COPYRIGHT HOLDERS AND CONTRIBUTORS "AS IS" -- AND ANY EXPRESS OR IMPLIED WARRANTIES, INCLUDING, BUT NOT LIMITED TO, THE -- IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE -- ARE DISCLAIMED. IN NO EVENT SHALL THE COPYRIGHT HOLDER OR CONTRIBUTORS BE -- LIABLE FOR ANY DIRECT, INDIRECT, INCIDENTAL, SPECIAL, EXEMPLARY, OR -- CONSEQUENTIAL DAMAGES (INCLUDING, BUT NOT LIMITED TO, PROCUREMENT OF -- SUBSTITUTE GOODS OR SERVICES; LOSS OF USE, DATA, OR PROFITS; OR BUSINESS -- INTERRUPTION) HOWEVER CAUSED AND ON ANY THEORY OF LIABILITY, WHETHER IN -- CONTRACT, STRICT LIABILITY, OR TORT (INCLUDING NEGLIGENCE OR OTHERWISE) -- ARISING IN ANY WAY OUT OF THE USE OF THIS SOFTWARE, EVEN IF ADVISED OF THE -- POSSIBILITY OF SUCH DAMAGE. WITH Ada.Text_IO; USE Ada.Text_IO; WITH errno; USE errno; WITH LPC1114IOP.GPIO; USE LPC1114IOP.GPIO; WITH LPC1114IOP.Interrupt; USE LPC1114IOP.Interrupt; WITH LPC1114IOP.Pins; USE LPC1114IOP.Pins; WITH LPC1114IOP.Transport; PROCEDURE test_lpc1114iop_int IS input_pin : LPC1114IOP.GPIO.GPIOPinClass; intr_pin : Integer; error : Integer; BEGIN New_Line; Put_Line("Raspberry Pi LPC1114 I/O Processor Interrupt Test"); New_Line; -- Initialize the SPI Agent Firmware transport library LPC1114IOP.Transport.Open("ioctl://localhost" & ASCII.NUL); -- Configure an LPC1114 pin as input with pull-up, with interrupt enabled input_pin.Initialize(LPC1114_GPIO0, GPIO_MODE_INPUT, GPIO_INTERRUPT_FALLING); -- Enable interrupt monitoring on Raspberry Pi INT (GPIO4) interrupt_enable(error); IF error /= 0 THEN RAISE LPC1114IOP.Error WITH "interrupt_enable() failed, error:" & error'Image; END IF; Put_Line("Press CONTROL-C to quit"); New_Line; LOOP interrupt_wait(1000, intr_pin, error); CASE error IS WHEN EOK => -- poll() event received or timed out IF intr_pin /= 0 THEN Put_Line("Received interrupt on GPIO pin" & intr_pin'Image); END IF; WHEN EINTR => -- poll() interrupted by signal EXIT; WHEN OTHERS => -- poll() failed RAISE LPC1114IOP.Error WITH "interrupt_wait() failed, error:" & error'Image; END CASE; END LOOP; New_Line; Put_Line("Terminating."); New_Line; -- Return the LPC1114 pin to default configuration input_pin.ConfigureMode(GPIO_MODE_INPUT_PULLUP); input_pin.ConfigureInterrupt(GPIO_INTERRUPT_DISABLED); -- Disable interrupt monitoring on Raspberry Pi INT (GPIO4) interrupt_disable(error); IF error /= 0 THEN RAISE LPC1114IOP.Error WITH "interrupt_disable() failed, error:" & error'Image; END IF; -- Close the SPI Agent Firmware transport library LPC1114IOP.Transport.Close; END test_lpc1114iop_int;