-- Raspberry Pi LPC1114 I/O Processor button and LED test -- Copyright (C)2017-2026, Philip Munts, President, Munts AM Corp. -- -- Redistribution and use in source and binary forms, with or without -- modification, are permitted provided that the following conditions are met: -- -- * Redistributions of source code must retain the above copyright notice, -- this list of conditions and the following disclaimer. -- -- THIS SOFTWARE IS PROVIDED BY THE COPYRIGHT HOLDERS AND CONTRIBUTORS "AS IS" -- AND ANY EXPRESS OR IMPLIED WARRANTIES, INCLUDING, BUT NOT LIMITED TO, THE -- IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE -- ARE DISCLAIMED. IN NO EVENT SHALL THE COPYRIGHT HOLDER OR CONTRIBUTORS BE -- LIABLE FOR ANY DIRECT, INDIRECT, INCIDENTAL, SPECIAL, EXEMPLARY, OR -- CONSEQUENTIAL DAMAGES (INCLUDING, BUT NOT LIMITED TO, PROCUREMENT OF -- SUBSTITUTE GOODS OR SERVICES; LOSS OF USE, DATA, OR PROFITS; OR BUSINESS -- INTERRUPTION) HOWEVER CAUSED AND ON ANY THEORY OF LIABILITY, WHETHER IN -- CONTRACT, STRICT LIABILITY, OR TORT (INCLUDING NEGLIGENCE OR OTHERWISE) -- ARISING IN ANY WAY OUT OF THE USE OF THIS SOFTWARE, EVEN IF ADVISED OF THE -- POSSIBILITY OF SUCH DAMAGE. -- NOTE: The button input has the internal pullup resistor enabled, so the -- switch should be connected from GPIO0 to ground. WITH Ada.Command_Line; USE Ada.Command_Line; WITH Ada.Strings.Unbounded; USE Ada.Strings.Unbounded; WITH Ada.Text_IO; USE Ada.Text_IO; WITH CRT; WITH GPIO; WITH LPC1114IOP.GPIO; USE LPC1114IOP.GPIO; WITH LPC1114IOP.Pins; USE LPC1114IOP.Pins; WITH LPC1114IOP.Transport; PROCEDURE test_lpc1114iop_button_led IS servername : Unbounded_String; Button : GPIO.Pin; LED : GPIO.Pin; newstate : Boolean; oldstate : Boolean; BEGIN Put_Line("Raspberry Pi LPC1114 I/O Processor Button and LED Test"); New_Line; -- Analyze command line parameters IF Argument_Count = 0 THEN servername := To_Unbounded_String("localhost"); ELSIF Argument_Count = 1 THEN servername := To_Unbounded_String(Argument(1)); ELSE Put_Line("Usage: " & Command_Name & " [hostname]"); RETURN; END IF; -- Initialize the SPI Agent Firmware transport library LPC1114IOP.Transport.Open(To_String(servername) & ASCII.NUL); -- Configure the LED pin Button := Create(LPC1114_GPIO0, Standard.GPIO.Input); LED := Create(LPC1114_LED, Standard.GPIO.Output); -- Force initial detection oldstate := Button.Get; LOOP newstate := NOT Button.Get; IF newstate /= oldstate THEN IF newstate THEN Put_Line("PRESSED"); LED.Put(True); ELSE Put_Line("RELEASED"); LED.Put(False); END IF; oldstate := newstate; END IF; EXIT WHEN CRT.KeyPressed; END LOOP; END test_lpc1114iop_button_led;